|Maximum image size||12MP|
|Lens||F=7.45; FOV=55°Auto IR-Cut-Remove(at night)|
|Display Screen||1.5inch B-W Display;36LEDs|
|Memory Card||SD or SDHC Card, Maximum capacity 32GB|
|Image Size||12MP (3000×4000);8M (3264×2448) ; 3M (2048X1536) ;|
|Video Size||1280×720; 640x360；|
|PIR Sensitivity||PIR with 4sensitivity levels :High/ Normal/ Low/Auto|
|Response Time||0.7 s|
|Triggering Interval||1sec-60min programmable|
|Shooting Numbers||1-3 programmable|
|Video Length||5-60sec. programmable|
|Power Supply||8×AA recommended|
|Power Consumption||<180mA(+800mA when IR-LED Lighted)|
|Interface||USB;SD card holder|
|Operating Temperature||-20-60℃(Storage temperature:-30-70℃)|
This KEEPGUARD CAM is the best-selling scouting camera which is
designed for activity and is resistant against water and snow. It
is equipped with built-in infrared LEDs, so that it can be
triggered by any movement in a location, then take high quality
pictures or video clips.
After opening the two latches on the right side of the camera, you
will see that it has 8 battery slots. For maximum battery life, we
recommend using 8 lithium AA or alkaline AA batteries.
Using an External Power Source
Optionally, you can connect an external 6V DC power source to the
"DC In" jack at the bottom of camera. It is recommended to use a
power source with a current output greater than 1000mA. Please make
sure that the polarity is correct.
Inserting SD Card
This camera have 32MB internal memory, which is for camera upgrade.
Insert the SD card ( OFF mode ) before beginning to operate the
camera. SD card is supported up to maximum 32GB capacity.
Formatting the SD card:
Formatting the SD card removes all files on the memory card and
prepares for camera. Press the MENU, then RIGHT or LEFT key several
more times to move to the “Format” parameter setting menu. Press OK
key to enter sub-menu, Press the UP or DOWN key to highlight YES
and press OK.
THE OFF, ON, and SETUP MODES
The KEEPGUARD CAM has three basic operational modes:
The OFF mode is the "safe" mode when any actions must be taken,
e.g. replacing the SD card or batteries, or transporting the
device. You will use OFF mode if you connect the camera to a
computer′s USB port to download your photos/videos.
Once in ON mode no manual controls are needed or possible (the
control keys have no effect). The KEEPGUARD CAM will take photos or
videos automatically (according to its current parameter settings)
when it is triggered by the PIR sensor′s detection of activity in
the area it covers.
In the SETUP mode you can check and change the settings of the
KEEPGUARD CAM with the help of built-in LCD. Moving the power
switch to the SETUP position will turn on the LCD display and you
will see an information screen.